I hope this is the right forum, i have the other guys clip but i cant for the life of me figure out how to set it up to get a proper dump. does anyone know what position the dip switch is supposed to be in? and what is the wire with the pogo pin for? is it a ground?
The probe wire is a 3.3v pin so please do not short anything out as there is no reverse polarity protection. Also the dip switch is dependent on your model. You also need to ensure the correct pin-out as well to whatever programmer you are using.
i.imgur.com/CNjWeKX.jpg
this is the way i have it wired, its an early 2014 air which im told is identical to a 2013
i keep getting this error
Calibrating delay loop... OK.
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.
This website uses cookies to manage authentication, navigation, and other functions. By using our website, you agree that we can place these types of cookies on your device.
You have declined cookies. This decision can be reversed.
You have allowed cookies to be placed on your computer. This decision can be reversed.
This website uses cookies to manage authentication, navigation, and other functions. By using our website, you agree that we can place these types of cookies on your device.